Open Policy Analyzer and Optimizer and select a data source

You can open Policy Analyzer and Optimizer from Security Cloud Control Firewall Management or cross-launch from supported On-Premises Firewall Management Center policy pages.

Follow these steps to open Policy Analyzer and Optimizer and select a data source:

Procedure

Step 1

In the Security Cloud Control Firewall Management left pane, choose Administration > Integrations > Firewall Management Center.

Step 2

Select Cloud-Delivered FMC or an On-Premises Firewall Management Center.

Step 3

Click Policy Analyzer and Optimizer under System.

Note	Alternatively, choose Insights & Reports > AIOps Insights > Policy Analyzer and Optimizer.

Step 4

Use the data source selector at the top of the Policy Analyzer and Optimizer page to choose the Cloud-Delivered Firewall Management Center or On-Premises Firewall Management Center whose policies you want to review.

Step 5

Choose the Access Control tab or the Network address translation tab, depending on the policy type that you want to analyze.

Note

If the selected data source is not enabled for AIOps, the Network address translation tab displays a message explaining that NAT Policy Analyzer and Optimizer requires AIOps for the selected data source. You can still use access control Policy Analyzer and Optimizer if the access control prerequisites are met.

If the selected data source is not enabled for AIOps, the Network address translation tab will show a message indicating that the NAT Policy Analyzer and Optimizer require AIOps for the selected data source. However, you can still utilize the access control Policy Analyzer and Optimizer if the access control prerequisites are met.