ASA Interface Configuration

Security Cloud Control simplifies ASA interface configuration by providing a user-friendly interface that eliminates the need to use the command line interface. You have complete control over configuring the ASA's physical interfaces, subinterfaces, and EtherChannels. Moreover, you can also view Virtual Tunnel Interfaces that are created during route-based site-to-site VPN, but they are read-only. You can use Security Cloud Control to configure and edit data interfaces or the management/diagnostic interface on an ASA device.

When you attach a cable to an interface connection (physically or virtually), you need to configure the interface. At minimum, you need to name the interface and enable it for traffic to pass through it. If the interface is a member of a bridge group, naming the interface is sufficient. If the interface is a bridge virtual interface (BVI), you need to assign the BVI an IP address. If you intend to create VLAN subinterfaces rather than a single physical interface on a given port, you would typically configure the IP addresses on the subinterface, not on the physical interface. VLAN subinterfaces let you divide a physical interface into multiple logical interfaces that are tagged with different VLAN IDs.

The interface list shows the available interfaces, their names, addresses, and states. You can change the state of an interface, on or off, or edit an interface, by selecting the interface row and clicking Edit in the Actions pane. The list shows the interface characteristics based on your configuration. Expand an interface row to see subinterfaces or bridge group member.

Management Interface

You can manage the ASA by connecting to:

  • Any through-traffic interface

  • A dedicated Management Slot/Port interface (if available for your model)

Use MTU Settings

The MTU specifies the maximum frame payload size that the device can transmit on a given Ethernet interface. The MTU value is the frame size without Ethernet headers, VLAN tagging, or other overhead. For example, when you set the MTU to 1500, the expected frame size is 1518 bytes including the headers, or 1522 when using VLAN. Do not set the MTU value higher to accommodate these headers.

Read-only Support for Virtual Tunnel Interface (VTI)

Configuring a route based site-to-site VPN tunnel between two ASA devices creates a Virtual Tunnel Interface (VTI) between the devices. Devices with configured VTI tunnels can be onboarded to Security Cloud Control, which discovers and lists them on the ASA Interfaces page but doesn't support their management.